Ehdotuksen tiedot

Tunnus:prEN 17979
Julkaisija:CEN
Komitea:CEN/TC 51
Komitean nimi:Cement and building limes
Lausuntokierros alkanut:2023-05-14
Lausuntopyynnön määräaika:2023-07-13
Vastuuhenkilö:ari.mantila(at)rakennusteollisuus.fi
Ehdotuksen soveltamisala:
This document specifies two complementary test methods to assess the chemical reactivity of a pozzolanic or latent hydraulic cement constituent by measurements of heat of hydration (see Clause 5 and 8.3 Method A, Heat of Hydration) or bound water content (see Clause 5 and 8.4 Method B, Bound Water Content) of hydrated pastes composed of the cement constituent, calcium hydroxide, calcium carbonate, potassium sulfate, and potassium hydroxide cured at 40 °C for 72 h and 168 h (3 days and 7 days). These two test methods do not distinguish between latent hydraulic and pozzolanic reactivity. Therefore, these methods are used for measuring the chemical reactivity of following cement constituents as specified under EN 197 1 and EN 197 5: S, D, P, Q, V, W and T. These test methods are used in complement with the current specifications on cement constituent reactivity given by EN 197 1 and EN 197 5, i.e. the reactive silicon dioxide content measured according to EN 196 2 for cement constituents P, Q and V; the compressive strength of specified test mortars determined according to EN 196-1 for cement constituents W and T, and the pozzolanicity of pozzolanic cements according to EN 196 5 for CEM IV type cements according to EN 197-1. The test methods are used for qualification purposes if the cement constituents are tested at the fineness of the intended use. NOTE In case the test methods are used for purposes of comparison of intrinsic reactivity, cement constituents are tested at similar fineness, where possible. The test methods are also used for testing other new constituents that are latent hydraulic or pozzolanic and that are not covered by EN 197-1 and EN 197-5. However, for such new constituents the validity of the underlying correlations with strength development have not been verified; in consequence the test results can only be used for informative and indicative purposes. Furthermore, these test methods are used in manufacturing control of cement constituents for assessing their latent hydraulic or pozzolanic reactivity.

Rekisteröidyttyäsi Lausuntopyyntöpalvelun käyttäjäksi voit lukea standardiehdotuksia ja kommentoida niiden sisältöä.

Kun haluat kommentoida lukemaasi tekstiä, valitse Lue ehdotus ja anna muutosehdotuksesi kohdassa Jätä kommentti.

Voit myös kertoa mielipiteesi standardiehdotuksesta kokonaisuutena. Ota kantaa siihen, hyväksytkö standardiehdotuksen vahvistamisen standardiksi.