Ehdotuksen tiedot

Tunnus:prEN 14753
Julkaisija:CEN
Komitea:CEN/TC 322
Komitean nimi:Equipments for making and shaping of metals - Safety requirements
Lausuntokierros alkanut:2019-09-09
Lausuntopyynnön määräaika:2019-11-17
Vastuuhenkilö:Mika.Vartiainen(at)metsta.fi
Ehdotuksen soveltamisala:This document applies for plant (containing machinery and equipment) used in the process of continuous casting of liquid steel (hereafter referred to as continuous casting machine, CCM) as defined in 3.1.This document deals with all significant hazards, hazardous situations and events relevant to machinery and equipment for the continuous casting of steel, when they are used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer (see Clause 4).This document specifies the safety requirements to be met during design, assembly, transport, commissioning, operation, maintenance (as described in Clause 5) and decommissioning of the equipment.This document assumes that the machinery and equipment of the plant is operated and maintained by adequately trained and competent personnel (see 7.5). Manual intervention for setting, adjustment and maintenance is accepted as part of the intended use of the plant.This document assumes that the machinery is used with adequate workstation lighting conforming to EN 12464-1.NOTE National regulations regarding lighting should be considered and could differ from requirements of EN 12464-1.This document applies to:CCM for the transformation of molten liquid steel into solid products in sections (e.g., square, rectangular, beam blank, circular)- CCM's from the point where overhead cranes or other transport systems deposit ladles to CCM (e.g., in a ladle turret, ladle car or ladle stand);- via casting process and solidification process;- via cutting equipment;- thru the run-out-area where the cut product is finished, collected and removed from that area.This document does not cover safety requirements for:- horizontal-CCM for steel;- auxiliary plants (e.g., water treatment, refractory handling);- ladles;- cranes;- winches and hoists;- conveyors or handling systems;- workshop equipment (mould and segment shop, tundish workshop).NOTE It is recommended to use this standard in case of modernization for the parts to be modernized.

Rekisteröidyttyäsi Lausuntopyyntöpalvelun käyttäjäksi voit lukea standardiehdotuksia ja kommentoida niiden sisältöä.

Kun haluat kommentoida lukemaasi tekstiä, valitse Lue ehdotus ja anna muutosehdotuksesi kohdassa Jätä kommentti.

Voit myös kertoa mielipiteesi standardiehdotuksesta kokonaisuutena. Ota kantaa siihen, hyväksytkö standardiehdotuksen vahvistamisen standardiksi.